Package contents

The µZ system is delivered in a sturdy case¹ and includes the following components:

1. Main tube assembly
   • Contains an enclosed speaker and 4 MEMS microphones.
2. Supportive base
3. Calibration/measurement tube (2x²)
   • Can also be used to mount samples during regular impedance tube measurements.
4. Hard end cap without tip microphone (2x²)
   • Used for measurements in 4 microphone mode.
5. Hard end cap with tip microphone
   • Used for measurements in 5 microphone mode.
6. Sample holder with 0.1 cc back cavity
   • Used for 5 microphone measurements on samples with relatively high series impedance.
7. Sample holder with 0.5 cc back cavity
   • Used for 5 microphone measurements on samples with relatively low series impedance.
8. Sample holder plate
   • Clamps the sample to the back cavity.
9. Sample holder plate mounting tool
   • Used to lock the sample holder plate in place.
10. Audio interface
    • Audient EVO 16
11. Required cabling
    • XLR cable (5x)
    • 1/4" TRS Jack cable, short
    • 1/4" TRS Jack cable, long
    • USB-A to USB-C cable
    • Power cable
    • 5 V power supply
12. Spare O-rings³
    • 22.5 x 1.5 mm (5x)
    •   7.0 x 1.5 mm (5x)
    • 10.5 x 1.5 mm (5x)

For series impedance measurements, additional sample holder disks are required. As they are tailor-made for the samples under test, they are not part of the regular contents. We can supply them on request.

1. The picture shows an old case layout. New µZ systems are delivered in cases that can fit all listed components. ↩

2. Only one is shown in the picture. ↩ ↩2

3. Not shown in the picture. ↩